Safron fo200 Power amplifier for bass guitar
Photograph shows the prototype fo200 Bass Power Amp, which was designed to drive the fo410 bass cab.
When Tom used the same amplifier with the fo Jazz 15, he found that the 15" enclosure sounded even better than before.
This was no doubt due to the extra headroom provided by a power supply that has enough spare capacity for when the amp
block is asked to deliver 400 watts into 4 ohms.
Specifications
| Dimensions | 3U 19" rack unit, 420 mm deep |
| Input sensitivity | 500mV unbalanced |
| Input impedance | 10k ohms |
| Maximum Power Output | 200 watts RMS into 8 ohms |
| | 400 watts RMS into 4 ohms |
| Frequency response | 5Hz to 50kHz |
| Output Noise | -95dBu |
- Designed around a high power amplifier block by Prism Audio Ltd, and special TW power supply
- RFI filtering on inputs, and AC power; Very low distortion and noise
- Input and output connector bonding to AES48 specifications; Meets the European EMC specifications: EN55103-1 & EN55103-2
595 GBP (874 Euros)
A deposit of 10% is required with your order; delivery is extra, but at cost...